LCD modding discussion

[MarkHaysHarris777]

          


Just for you Doc,  I removed the display module from the bezel;  came out very easily, just bent back the tiny plastic clips with a finger-nail.

The good news is that the glass panel mounted in the bezel front is for the touch-pad only;  it is NOT polarized and absent should not prevent the display from functioning. ( used polarized film from calculator display to test this )

I have two of these displays, neither of which I am using atm.  Now I have one in the bezel, and one out of the bezel;  should the display work ( have not tested yet ) I will probably remove both of them !



Note:   module is 16.3cm  by  9.6cm   metal frame at the bottom is  6mm;  5mm at side;  1.5mm around

Note:   front touch panel saved

         

The front touch panel may be saved and used as protection should that be necessary.  I have discarded the touch chip and cable.  The panel is double-sided taped to the bezel and comes off relatively easily.  The tapes can be removed.