I am not asking for a connector (that would cost money)
what I am asking for is this:
Will this be available?
NOTE: I also see there are two JTAG-SEL pins, These need to be "modifiable" by some means.
Option 1: A sufficient solution would be trace on the PCB that can be cut with a razor knife (this would be zero cost) please make these large enough that a human can actually do this.
Option 2: Would be to use some zero-ohm components that can be removed or changed
Also will need documentation about what these pins do, etc - they are not well documented in the existing PDFs on the Pine64 web site (the documents say the pins exist, but do not say what the pins do)
-Duane.
what I am asking for is this:
- At least Solderable pads that support JTAG
- Make sure JTAG is enabled (some SoC companies blow fuses to disable JTAG)
- Access to sufficent docs that are the chip specific JTAG (i.e.: Chain geometry, etc)
Will this be available?
NOTE: I also see there are two JTAG-SEL pins, These need to be "modifiable" by some means.
Option 1: A sufficient solution would be trace on the PCB that can be cut with a razor knife (this would be zero cost) please make these large enough that a human can actually do this.
Option 2: Would be to use some zero-ohm components that can be removed or changed
Also will need documentation about what these pins do, etc - they are not well documented in the existing PDFs on the Pine64 web site (the documents say the pins exist, but do not say what the pins do)
-Duane.