Mounting RPI3 "hats" on Pine64

[dkryder]

Hello,

Can a "hat", like the twinind 3.14-2 be mounted (screw/holder positioning) on top of a Pine64?

I would like to switch from rpi3 to pine64 on my pet project, and this is a crucial part. As I've seen the GPIO layout is the same.

Thanks in advance,
Gergely

that particular board could be made to fit with maybe regular female 2x20 and better with the longer stacked female 2x20 header. it is kinda strange how it fits though, hanging off the side. pine64 sells a proto which might do what you want and would fit better. look in the store if interested.