03-08-2017, 04:20 PM
(03-08-2017, 03:03 PM)g_t_j Wrote: I was talking about the jumper position (up/down) which supposedly allows the Pine to be powered by either DC or a lipo battery.
And all I asked for is someone to verify whether the position of the jumper in the above photo I uploaded is set to DC or to battery.
EDIT: I'm already powering the board through the Euler bus via a custom cable I made.
That is the vbatt position; you will only get 5v for usb (other) if the battery is plugged in. The jumper determines where the 5v is coming from for the bus(s) and for usb. If the jumper is in the DCIN position (its marked right on the board) then the 5v for usb comes from the DCIN connection. If the jumper is in vbatt position (as marked in your photo) the 5v comes from a step-up ®ulator derived from the lipo battery .
marcushh777
please join us for a chat @ irc.pine64.xyz:6667 or ssl irc.pine64.xyz:6697
( I regret that I am not able to respond to personal messages; let's meet on irc! )
please join us for a chat @ irc.pine64.xyz:6667 or ssl irc.pine64.xyz:6697
( I regret that I am not able to respond to personal messages; let's meet on irc! )