Configuring WiFi Module via SSH

[Chadilac]

Hi All,

I have been trying to setup my wifi module that came with the Pine64.
It seems to be recognized in iwconfig:

openhab@openhab:~$ iwconfig
eth0      no wireless extensions.

wlan0     unassociated  Nickname:"<WIFI@REALTEK>"
          Mode:Managed  Frequency=2.412 GHz  Access Point: Not-Associated
          Sensitivity:0/0
          Retry:off   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=0/100  Signal level=0 dBm  Noise level=0 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

dummy0    no wireless extensions.

sit0      no wireless extensions.

lo        no wireless extensions.

wlan1     unassociated  Nickname:"<WIFI@REALTEK>"
          Mode:Managed  Frequency=2.412 GHz  Access Point: Not-Associated
          Sensitivity:0/0
          Retry:off   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=0/100  Signal level=0 dBm  Noise level=0 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0


However when I try configuring I get an error:

Error for wireless request "Set ESSID" (8B1A) :

    SET failed on device wlan0 ; Operation not permitted.


Any help on how to get this connected to my secured network?
I can connect via my network currently with the pine plugged in and have access to http://openhab:8080 but havent seen wifi configuration tool in web interface.  I'm new to both openhab and commandline operations...

Thanks for any help!

Chad