PINE64   ›   PINE A64(+)   ›   Pine A64 Hardware, Accessories and POT   ›   POT modules   ›   Setting a specific pin to high status when the device powered

Setting a specific pin to high status when the device powered
mbt28
Pine Adept
***
Joined: Oct 2016
Posts: 49

Reputation: 1
#5
10-06-2016, 04:15 AM
Hi,

I can use both 3.3v or 5V logic, I have no issue with it. It has to be high immediately when the board powered and It should go to zero when the shutdown sequence completed, then the external linbus IC will cut all the supply until it receives a data on the line.

Thanks.
  Reply


Messages In This Thread
RE: Setting a specific pin to high status when the device powered - by mbt28 - 10-06-2016, 04:15 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Portable USB-Powered Monitor mribunal 4 10,495 02-03-2017, 05:28 AM
Last Post: stevenmeza07
  High speed I/O richw42 3 7,183 01-15-2017, 04:08 PM
Last Post: richw42
  Setting up UART2 for Adafruit GPS hat stephen fleming 1 3,803 05-13-2016, 03:20 PM
Last Post: peterz

Forum Jump:


Users browsing this thread: 1 Guest(s)