|
Where to start
|
09-30-2016, 06:10 AM
(This post was last modified: 09-30-2016, 06:14 AM by Freedom1029.)
I guess if I connect my Pine64 to the network via cable and boot, the device should appear in my router, and from there I could get it's ip address or by using some sort of IP scanning software. Then use Putty from my pc to connect to it using the ip, login and password.
Would that make sense? |
| Messages In This Thread |
|
Where to start - by Freedom1029 - 09-28-2016, 06:41 AM
RE: Where to start - by Ghost - 09-28-2016, 07:03 AM
RE: Where to start - by kai - 09-28-2016, 07:35 AM
RE: Where to start - by Ghost - 09-28-2016, 10:55 AM
RE: Where to start - by Freedom1029 - 09-29-2016, 06:21 AM
RE: Where to start - by Ghost - 09-29-2016, 06:40 AM
RE: Where to start - by pfeerick - 09-29-2016, 08:31 PM
RE: Where to start - by j.hoekstra - 09-30-2016, 03:25 AM
RE: Where to start - by pfeerick - 09-30-2016, 05:35 AM
RE: Where to start - by Freedom1029 - 09-30-2016, 06:10 AM
RE: Where to start - by j.hoekstra - 09-30-2016, 06:31 AM
RE: Where to start - by Freedom1029 - 09-30-2016, 02:07 PM
RE: Where to start - by pfeerick - 09-30-2016, 06:57 PM
|
