09-10-2016, 06:40 PM
(09-10-2016, 02:55 PM)MarkHaysHarris777 Wrote:(09-10-2016, 03:39 AM)pfeerick Wrote: So there is definitely something odd going on here... can you confirm if this is with the pine64 on or off, how it's powered, and which you're using? I'm starting to wonder if the PMIC on this board is a bit flaky... as there doesn't seem to be any good reason for it to be running so. Then again, datasheet isn't the best on some points - it doesn't detail what the charge 'smarts' of the PMIC is, if this one has any at all. It seems to indicate it only follows a CC/CV profile, with over-voltage/over-temp protection.
hi, I am presently running my Android batt to the ground ... then I'll start a change cycle and see what I can see by looking in sysfs.
I can do that same thing for my debian build too, as far as that goes.
I'm sorry, I'll repeat the question: Can you confirm if this is with the pine64 on or off, how it's powered, and which distro you're using?
I gather from you you just said that this might be on Android... is that correct? This would explain a lot of things (specifically, why registers might have been reconfigured from their defaults).
