09-10-2016, 10:29 AM
(09-07-2016, 03:16 PM)dmcwhinnie Wrote:(09-06-2016, 07:59 PM)Fgildred Wrote:(08-28-2016, 08:55 PM)psychedup Wrote: Today I received both of the ABS enclosures that I ordered from backerkit. I have to say, just like everything else I received earlier, the quality is outstanding. I have a case from another manufacturer that cost twice as much and is so cheap and flimsy, but not these - they're quite sturdy and fit together perfectly. I'm glad you didn't rush them but insisted on putting out quality products - in the end, I think that's what will define Pine64.
Just be glad you didn't order the IoT Kit. I recieved both enclosures today and with Zwave module installed, you can't close either box up-it sits too high. How unbelievably useless! Frustrating to say the least. To wait all this time, finally receive the enclosures and neither one of them can be used with the zwave module installed.
Any instructions on how to install the ZWave module? My case and ZWave and "something else" came today. But no details on how to install it. I assume the something else is the zwave antenna, but not really clear what it is.
Of course, If I can't actually use the case with the ZWave installed ...
I also just tried to set up my z wave module with the enclosure and the zwave module sits too high up to close the case...what are we supposed to do? Also an IoT kit backer....
