09-02-2016, 11:55 PM
Did anybody bringing both network interfaces, one in access point mode ? How does it work for you ?
I am concerned that both interfaces have same MAC address 34:c3:d2:7a:ba:77, and adding hwaddress in /etc/network/interfaces
does not change that. so my wlan0 connects to my home wifi router, that part works, but if i do that the access point on wlan0 does not work, clients can't connect to it
ifconfig
wlan0 Link encap:Ethernet HWaddr 34:c3:d2:7a:ba:77
inet addr:192.168.0.113 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::36c3:d2ff:fe7a:ba77/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1910 errors:0 dropped:53 overruns:0 frame:0
TX packets:1365 errors:0 dropped:1 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:277533 (277.5 KB) TX bytes:320881 (320.8 KB)
wlan1 Link encap:Ethernet HWaddr 36:c3:d2:7a:ba:77
inet addr:10.0.0.1 Bcast:10.0.0.15 Mask:255.255.255.240
inet6 addr: fe80::34c3:d2ff:fe7a:ba77/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:976 errors:0 dropped:0 overruns:0 frame:0
TX packets:1 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
iwconfig
wlan0 IEEE 802.11bgn ESSID:"yyyyy" Nickname:"<WIFI@REALTEK>"
Mode:Managed Frequency:2.447 GHz Access Point: 28:C6:8E:73:6E:07
Bit Rate:72.2 Mb/s Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:****-****-****-****-****-****-****-**** Security mode:open
Power Management:off
Link Quality=99/100 Signal level=-45 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
dummy0 no wireless extensions.
sit0 no wireless extensions.
lo no wireless extensions.
wlan1 IEEE 802.11bgn ESSID:"xxxxx" Nickname:"<WIFI@REALTEK>"
Mode:Master Frequency:2.447 GHz Access Point: 36:C32:7A:BA:77
Bit Rate:72.2 Mb/s Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/100 Signal level=-95 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
RX bytes:0 (0.0 B) TX bytes:112 (112.0 B)
I am concerned that both interfaces have same MAC address 34:c3:d2:7a:ba:77, and adding hwaddress in /etc/network/interfaces
does not change that. so my wlan0 connects to my home wifi router, that part works, but if i do that the access point on wlan0 does not work, clients can't connect to it
ifconfig
wlan0 Link encap:Ethernet HWaddr 34:c3:d2:7a:ba:77
inet addr:192.168.0.113 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::36c3:d2ff:fe7a:ba77/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1910 errors:0 dropped:53 overruns:0 frame:0
TX packets:1365 errors:0 dropped:1 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:277533 (277.5 KB) TX bytes:320881 (320.8 KB)
wlan1 Link encap:Ethernet HWaddr 36:c3:d2:7a:ba:77
inet addr:10.0.0.1 Bcast:10.0.0.15 Mask:255.255.255.240
inet6 addr: fe80::34c3:d2ff:fe7a:ba77/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:976 errors:0 dropped:0 overruns:0 frame:0
TX packets:1 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
iwconfig
wlan0 IEEE 802.11bgn ESSID:"yyyyy" Nickname:"<WIFI@REALTEK>"
Mode:Managed Frequency:2.447 GHz Access Point: 28:C6:8E:73:6E:07
Bit Rate:72.2 Mb/s Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:****-****-****-****-****-****-****-**** Security mode:open
Power Management:off
Link Quality=99/100 Signal level=-45 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
dummy0 no wireless extensions.
sit0 no wireless extensions.
lo no wireless extensions.
wlan1 IEEE 802.11bgn ESSID:"xxxxx" Nickname:"<WIFI@REALTEK>"
Mode:Master Frequency:2.447 GHz Access Point: 36:C32:7A:BA:77
Bit Rate:72.2 Mb/s Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/100 Signal level=-95 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
RX bytes:0 (0.0 B) TX bytes:112 (112.0 B)