08-22-2016, 08:41 PM
marcushh777, Thank you very much. Pin7 is what my mistake was, blinking led works with pin 11,13,15
while other leg of the LED connected to pin6 via 100 ohm resistor
I only need two pins for my relay project, so I am unblocked, thanks again you are awesome !
So then to trigger the relay, do i still need a resistor and what tolerance would you recommend (sorry my radio electronics skills are very limited
) ?
The circuit i am going to turn on and off via the relay powered by 4.3 volt battery, so there 's not a whole lot of power in that circuit.
while other leg of the LED connected to pin6 via 100 ohm resistor
I only need two pins for my relay project, so I am unblocked, thanks again you are awesome !
So then to trigger the relay, do i still need a resistor and what tolerance would you recommend (sorry my radio electronics skills are very limited
) ?The circuit i am going to turn on and off via the relay powered by 4.3 volt battery, so there 's not a whole lot of power in that circuit.