PINE64   ›   PINE A64(+)   ›   Pine A64 Hardware, Accessories and POT   ›   Ethernet Port   ›   Howto test and tune Gigabit Networking (1000M)

Howto test and tune Gigabit Networking (1000M)
ubuntuGuy
Pine Initiate
**
Joined: Jun 2016
Posts: 5

Reputation: 0
#7
08-22-2016, 03:22 PM (This post was last modified: 08-22-2016, 05:57 PM by ubuntuGuy.)
I tested it with my WNDR3700 router running openwrt and here is my results:

[ ID] Interval           Transfer     Bandwidth       Retr
[  4]   0.00-30.00  sec   884 MBytes   247 Mbits/sec    1             sender
[  4]   0.00-30.00  sec   883 MBytes   247 Mbits/sec                  receiver

seems to be slower than what it is supposed to be. any suggestions?

Edit : never mind. did the same test from my desktop to router and got similar result, so it should be my network settings. will try to figure it out.
  Reply


Messages In This Thread
RE: Howto test and tune Gigabit Networking (1000M) - by ubuntuGuy - 08-22-2016, 03:22 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Howto use MAC address as printed on the label on the back longsleep 3 6,690 08-21-2016, 07:31 AM
Last Post: MarkHaysHarris777

Forum Jump:


Users browsing this thread: 21 Guest(s)