08-18-2016, 06:00 PM
(08-18-2016, 05:46 PM)Severian Wrote:(08-16-2016, 06:08 PM)DonFL Wrote: Soldered properly, its fine. You have two pins as switch contact, two pins purely for mounting/stability.
You can also use the 10 pin connector, which sounds like the better option for what you want to do, take a look at page 3: http://files.pine64.org/doc/Pine%20A64%2...160119.pdf
so if I'm looking at this right, the power switch would be pin 5, and what? Pin 6? and the reset switch would be pin 4 and ? Have a couple of momentary push button switches I picked up on ebay, and they would mount on 2 pins each, just want to make sure I get the right pins, lol.
Both the power switch (pin 5) and the reset switch (4) also each require a ground wire, so to either pin 6 or pin 9.
