When & How to use resize_rootfs.sh?

[jesse1234]

Thanks Terra

Well I did as suggested. I went back and pulled up the command histroy and it actually did something. Below are the results but after rebooting, the Disk Usage Analyzer still shows 7.5 GB.

Code:

debian@pine64:~$ sudo usr/local/sbin/resize_rootfs.sh [sudo] password for debian: sudo: usr/local/sbin/resize_rootfs.sh: command not found debian@pine64:~$ sudo resize_rootfs.sh + DEVICE=/dev/mmcblk0 + PART=2 + resize + fdisk -l /dev/mmcblk0 + grep /dev/mmcblk0p2 + awk {print $2} + start=143360 + echo 143360 143360 + set +e + fdisk /dev/mmcblk0 Welcome to fdisk (util-linux 2.25.2). Changes will remain in memory only, until you decide to write them. Be careful before using the write command. Command (m for help): Disk /dev/mmcblk0: 29.7 GiB, 31914983424 bytes, 62333952 sectors Units: sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disklabel type: dos Disk identifier: 0xa2427f8e Device Boot Start End Sectors Size Id Type /dev/mmcblk0p1 40960 143359 102400 50M e W95 FAT16 (LBA) /dev/mmcblk0p2 143360 14884863 14741504 7G 83 Linux Command (m for help): Partition number (1,2, default 2): Partition 2 has been deleted. Command (m for help): Partition type p primary (1 primary, 0 extended, 3 free) e extended (container for logical partitions) Select (default p): Partition number (2-4, default 2): First sector (2048-62333951, default 2048): Last sector, +sectors or +size{K,M,G,T,P} (143360-62333951, default 62333951): Last sector, +sectors or +size{K,M,G,T,P} (143360-62333951, default 62333951): Do you really want to quit? + set -e + partx -u /dev/mmcblk0 + resize2fs /dev/mmcblk0p2 resize2fs 1.43 (17-May-2016) The filesystem is already 1842688 (4k) blocks long. Nothing to do! + echo Done! Done! debian@pine64:~$

Any suggestions at this time would be most appreciative.

Jesse