PINE64   ›   PINE A64(+)   ›   Pine A64 Hardware, Accessories and POT   ›   DC Power In   ›   5v|batt jumper next to Pine logo on the Pine64+ board

5v|batt jumper next to Pine logo on the Pine64+ board
MarkHaysHarris777
Professor of The Pine
*****
Joined: Mar 2016
Posts: 1,948

Reputation: 148
#4
07-01-2016, 08:20 AM
Thanks mates ! ... makes sense. Looking forward to being able to compare the 1G schematics with the 2G schematics. I have been receiving questions about whether its 'ok' to power the board from the 5v pin on either the Euler bus, or the PI bus; without harming the power circuit/ was wondering how the jumper worked into that scenario.

tnx again.
  Reply


Messages In This Thread
RE: 5v|batt jumper next to Pine logo on the Pine64+ board - by MarkHaysHarris777 - 07-01-2016, 08:20 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Which Power Supply Unit for Pine64 A64 DB V1.1 2GB REV B (year 2016)? databaseprogrammer 1 3,654 07-03-2021, 01:29 AM
Last Post: tllim
Lightbulb Alternate Power DC-IN on the Euler Bus also with PI filter for batt operation MarkHaysHarris777 13 28,136 12-19-2020, 09:53 PM
Last Post: evilpete
  Once Again: Power Supply problems I guess (Pine A64+ locking up) marcelser 0 3,838 06-04-2018, 03:11 PM
Last Post: marcelser
  solar power on a Pine64 tablet Little_Johnny 11 18,873 03-20-2018, 12:01 AM
Last Post: pfeerick
Sad Fried Pine64 Israeldelamo 0 2,990 07-24-2016, 12:42 AM
Last Post: Israeldelamo
  DC Power IN Power-ON Switch Reset Switch -- Batt Required MarkHaysHarris777 6 13,839 06-25-2016, 01:17 AM
Last Post: xalius
  Can I Use 2 Pine Power Supplies on 1 Pine A64 Board Using the Euler Port? Bob123456789 2 5,671 05-10-2016, 05:48 PM
Last Post: Bob123456789
  Power Pine64 via GPIO dulasu 15 34,293 05-06-2016, 04:24 PM
Last Post: xmasone

Forum Jump:


Users browsing this thread: 6 Guest(s)