06-23-2016, 10:25 PM
My little project for tonight (I forget how shaky my hands are until I start soldering..)
![[Image: 2a4xnxy.jpg]](http://i67.tinypic.com/2a4xnxy.jpg)
![[Image: 28hzrqp.jpg]](http://i63.tinypic.com/28hzrqp.jpg)
I'm using a USB-A 2.0 connector on the one end (for my Anker power brick) and a .1" pitch 3 pin receptacle on the other end, with 20 gauge wire in between.
I threw some braided cabling and heat shrink on to cover up my sins
If there is any interest in a more detailed write-up and part numbers etc. just post here and I should be able to get it up sometime this weekend~
AVL
I'm using a USB-A 2.0 connector on the one end (for my Anker power brick) and a .1" pitch 3 pin receptacle on the other end, with 20 gauge wire in between.
I threw some braided cabling and heat shrink on to cover up my sins
If there is any interest in a more detailed write-up and part numbers etc. just post here and I should be able to get it up sometime this weekend~
AVL
