I just received my replacement Pinephonepro system board.
I had a tow-boot bootable SD ready to begin the process but the phone now loads a Rockchip splash and then boots into Chinese Android.
It also doesn't auto-boot when plugged into power, it just charges as it is an android.
How can I force this to bootfrom SD?
I wonder if this requires ADB commands?
I also wonder if the board requires ADB unlocking now as it is loaded with android...
I do not dread/write/speak Chinese so I have no idea how to get into dev mode.
A side problem is the main camera socket keeps popping off from the new board, I tried adding a paper shim to push it down via pressure form the plastic enclosure when screwed down. I wonder if it is broke and I need to spend $30 replacing the camera.
it also seems that the proximity detector is not fully pushed into its place as I can see the notification LED, this probably just needs to be opened and pushed down or remove the shim from the main camera.
(edit)
https://wiki.radxa.com/Rock/SD_booting
this is for rockchip not sure if it will do anything useful for me, I want to be careful that I dont do more damage.
This just seems to be a windoze SD card writer app which can flip the bootable bit
per the dev boards(r-pi like boards) stuff here https://wiki.radxa.com/Rock/dual_boot
You can flash over those board's /recovery partition, if I could get that much access from my phone
For now this might as well be bricked unless I reinsert the broken board that cant use hibernate mode and cant boot without a good smack(detached RF shield), I wonder if I can interfere with anything to force a SD boot using the serial cable?
I had a tow-boot bootable SD ready to begin the process but the phone now loads a Rockchip splash and then boots into Chinese Android.
It also doesn't auto-boot when plugged into power, it just charges as it is an android.
How can I force this to bootfrom SD?
I wonder if this requires ADB commands?
I also wonder if the board requires ADB unlocking now as it is loaded with android...
I do not dread/write/speak Chinese so I have no idea how to get into dev mode.
A side problem is the main camera socket keeps popping off from the new board, I tried adding a paper shim to push it down via pressure form the plastic enclosure when screwed down. I wonder if it is broke and I need to spend $30 replacing the camera.
it also seems that the proximity detector is not fully pushed into its place as I can see the notification LED, this probably just needs to be opened and pushed down or remove the shim from the main camera.
(edit)
https://wiki.radxa.com/Rock/SD_booting
this is for rockchip not sure if it will do anything useful for me, I want to be careful that I dont do more damage.
This just seems to be a windoze SD card writer app which can flip the bootable bit
per the dev boards(r-pi like boards) stuff here https://wiki.radxa.com/Rock/dual_boot
You can flash over those board's /recovery partition, if I could get that much access from my phone
For now this might as well be bricked unless I reinsert the broken board that cant use hibernate mode and cant boot without a good smack(detached RF shield), I wonder if I can interfere with anything to force a SD boot using the serial cable?
