|
touchscreeh doesn't accept input
|
06-19-2025, 01:13 AM
Have you tried booting a fresh image off an SD card to check if the problem is software or hardware? You could even try installing Megi's u-boot since it supports touch at the bootloader stage (see https://xnux.eu/log/098.html, just unzip on the phone and run sudo ./spinor-flash-initial-setup.sh)
|
| Messages In This Thread |
|
touchscreeh doesn't accept input - by henrythemouse - 06-09-2025, 11:55 PM
RE: touchscreeh doesn't accept input - by Merc - 06-10-2025, 09:30 PM
RE: touchscreeh doesn't accept input - by henrythemouse - 06-12-2025, 02:25 PM
RE: touchscreeh doesn't accept input - by Merc - 06-13-2025, 12:29 PM
RE: touchscreeh doesn't accept input - by henrythemouse - 06-14-2025, 03:58 PM
RE: touchscreeh doesn't accept input - by teekay - 06-19-2025, 01:13 AM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| PinePhone's LED is blinking, but doesn't start | zvavybir | 0 | 667 |
09-06-2024, 02:39 AM Last Post: zvavybir |
|
|
Pinephone pro doesn't boot up anymore | giacomo986 | 2 | 3,122 |
08-10-2022, 08:25 AM Last Post: giacomo986 |
