(07-13-2023, 05:03 AM)nfeske Wrote: BTW, do you happen to have a USB-serial cable for your PinePhone (via the audio jack) to glimpse at log messages?
Did the following to get a baseline:
1) Turned on Sculpt, enabled phone, hit reboot and it rebooted quickly.
2) On the reboot, I selected the power down option turning off the phone, waited 20 seconds and then hit the power button on the side of the phone and Sculpt popped up quickly.
The issue is when including Storage:
Followed step 1 again except this time clicked Format under Storage and waited until is showed the USE button and hit the reboot button, waited 10 seconds, screen saver popped on, hit volume button, and then hit confirm on the reboot which started the reboot which as before briefly flashed the Sculpt screen and then went black again and finally showed the red light in the upper left and shows the "K" gear logo spinning indicating Manjaro was booting up.
I did the "holding the power button for 5 seconds" option, but the SD card appears to get altered immediately after the red light pops on since the SD card title when checked on a laptop goes from "GENODE" to "16 GB Volume." The folders in the post reboot SD shows depot and inside of that folder multiple folders, probably about a dozen with each of those folders housing a 'download' and 'pubkey' folder with a locked symbol on each one.
I think I know why this is happening. The [1] box on the far left is not popping up after formatting the Storage like with previous Sculpt versions. I recall hitting [1] being an important step to make the formatting complete.
After multiple sequences of hitting "Format", "Check", "USE" on and off, I only saw the [1] box pop up once and when I went to hit it, it triggered a blank screen since clicking the far left screen also triggers the preset options. Still don't know the proper sequence to get [1] to show up consistently to verify if this is indeed the fix.
Mentioned previously it would be great to make the [1] box bigger and moved to the center or right side so it isn't in the same spot as the preset trigger on the left screen.
So I believe that's the issue. If still needed, I can get a hold of a PP socket to USB chord that I can put a flash USB into to send a log file to, but it will be sometime next week and step by step instructions would be nice since I don't know the code to put into the Sculpt terminal to transfer the log file to the USB drive.
