10-14-2022, 02:09 AM
(This post was last modified: 10-14-2022, 02:16 AM by Juan_Mann.
Edit Reason: Bonux content
)
The wiki for the NAS case has a nice suggested parts list, the Slackware installation guide recommends a SATA controller with the MZHOU / Marvell chipset and counsels against using eMMC memory in a live system because they are not robust enough for long term use.
I went with the NAS case, 4G RockPro64, Wifi card, case fan, tall heat sink, 5A power supply, don't forget a CMOS battery. I sourced a SATA card elsewhere and will run 2 SATA devices comfortably.
P=iv 60w=5Ax12v
Most 2.5" SSD or HDD draw approx 10w peak I don't see an issue.
I of course will be installing Slackware but your options are wide open.
I have it all assembled, will have install done in a few days hopefully.
ETA: I picked up a 500GB SSD at Wally World for $55- it came with a USB to SATA adapter - BONUS!!
https://wiki.pine64.org/wiki/NASCase
https://docs.slackware.com/slackwarearm:..._rockpro64
I went with the NAS case, 4G RockPro64, Wifi card, case fan, tall heat sink, 5A power supply, don't forget a CMOS battery. I sourced a SATA card elsewhere and will run 2 SATA devices comfortably.
P=iv 60w=5Ax12v
Most 2.5" SSD or HDD draw approx 10w peak I don't see an issue.
I of course will be installing Slackware but your options are wide open.
I have it all assembled, will have install done in a few days hopefully.
ETA: I picked up a 500GB SSD at Wally World for $55- it came with a USB to SATA adapter - BONUS!!
https://wiki.pine64.org/wiki/NASCase
https://docs.slackware.com/slackwarearm:..._rockpro64