08-09-2022, 03:22 PM
I just got my modules for the DeskPi Super6C today and am experimenting with it. One notable thing I ran into is being unable to successfully reboot. It shuts down correctly AFAICT but then never comes back up. I need to either long press the power button on the Super6C or unplug and plug the power to the board to get it to reboot again.
Would be nice to know that this is also the case with your setup @adamfowleruk
Another thing I'm struggling with currently is to get the nvme drive to work. I get the following output in dmesg (filtered by "nvme"):
Would be nice to know that this is also the case with your setup @adamfowleruk
Another thing I'm struggling with currently is to get the nvme drive to work. I get the following output in dmesg (filtered by "nvme"):
Code:
[ 0.603723] nvme nvme0: pci function 0000:01:00.0
[ 0.603824] nvme 0000:01:00.0: enabling device (0000 -> 0002)
[ 0.629624] nvme nvme0: allocated 64 MiB host memory buffer.
[ 0.639069] nvme nvme0: 4/0/0 default/read/poll queues
[ 31.896584] nvme nvme0: controller is down; will reset: CSTS=0xffffffff, PCI_STATUS read failed (134)
[ 34.044873] nvme0n1: I/O Cmd(0x2) @ LBA 488396928, 8 blocks, I/O Error (sct 0x3 / sc 0x71)
[ 34.044887] I/O error, dev nvme0n1, sector 488396928 op 0x0:(READ) flags 0x80700 phys_seg 1 prio class 0
[ 34.095180] nvme 0000:01:00.0: Unable to change power state from D3cold to D0, device inaccessible
[ 34.146540] nvme nvme0: Removing after probe failure status: -19
[ 34.195357] Buffer I/O error on dev nvme0n1, logical block 61049616, async page read
[ 34.195420] nvme0n1: detected capacity change from 488397168 to 0