Amazing!
Thanks so much both of you guys!
I did finally locate the 2 pins providing 5V based on the diagram you provided and have successfully powered a 5V fan but was a bit reluctant to try anything on the Euler bus. There is no room for mistakes there as you can easily fry the board...
With that image, however, I'm on safe ground! I will make a USB-to-2 pin cable and will try to power the board!
Cheers!
Thanks so much both of you guys!
I did finally locate the 2 pins providing 5V based on the diagram you provided and have successfully powered a 5V fan but was a bit reluctant to try anything on the Euler bus. There is no room for mistakes there as you can easily fry the board...
With that image, however, I'm on safe ground! I will make a USB-to-2 pin cable and will try to power the board!
Cheers!