07-07-2022, 03:35 AM
(This post was last modified: 07-07-2022, 03:35 AM by CounterPillow.)
(07-06-2022, 11:12 AM)emveepee Wrote: When I say I can boot any Linux or LE via SD card that would be with no emmc card in.
I also see nothing on the console on UART0 via pin 12/14 in minicomm at various baudrate. This /dev/ttyUSB0 device works fine with other devices Should I be using UART2?
I do have BAT1 open and I have read that might need to be closed.
Martin
Hello,
you need to connect to UART2 at 1.5 mbauds. Also, the BAT ON/OFF jumper needs to be closed if you don't have a battery connected, otherwise you will run into boot failures.
Occasional Linux Kernel Contributor, Avid Wiki Updater, Ask Me About Quartz64
Open Hardware Quartz64 Model A TOSLink Adapter
Pi-bus GPIO Extender For ROCKPro64 And Quartz64 Model A
Plebian GNU/Linux