No Power after install new emmc and front touchscreen
09-19-2021, 12:43 PM
(09-19-2021, 11:20 AM)kqlnut Wrote:(09-19-2021, 10:16 AM)lot378 Wrote: I suspect the battery contains no charge - charging the battery is difficult if the phone does not boot. Do you have the Pine64 standalone battery charger for the PinePhone? I suggest using this or some other means to charge the battery outside of the PinePhone and then try booting the phone again.
See: https://pine64.com/product/pinephone-battery-charger/
If still does not boot then will need to check all the connections, checking the connectors for damage.
In case of very low battery, there is a version of Jumpdrive specifically designed for this which could help.
Maybe it has to do with the ANX firmware? I never replaced the mainboard, but the wiki says (and I remember reading about people having to do that too) to flash the ANX firmware for full USB functionality.
And of course you need an OS in the first place. Since the replacement mainboard has no OS preinstalled, you have to insert an SD card with an OS or Jumpdrive if you didn't already.
Hi, lot378,
Thanks for the reply. Once I place the SDCard with PostmarketOS in it, it just start booting. I believe I will needed to Flash the emmc with an OS first, stupid me.