Individual SOPINE Power On After Shutdown?

[Pine]

On the clusterboard v2.2 the reset button won't restart shutdown SOPINE modules - they stay off with a dim PL7 green light. Any suggestions to restart individual SOPINEs? 

I'm leaning toward shorting the VCC and GND on the jumper pins beside each SOPINE. I could rig each set of jumpers with a toggle switch. Any suggestions on the best way to do this without harming my SOPINEs?

[jbobspants]

Maybe I'm not understanding you right, but typically shorting VCC directly to GND in any environment is a bad idea.

I would also like to know if there is a way to power on individual SOPINEs after they've been shutdown. As you mention, shorting pin 4 (RESET) to ground does not trigger a power-on, although it does force-reboot a running SOPINE. I've tried pin 5, which is labeled PWR_ON, but neither shorting it to ground nor VCC seem to have any effect. Unless I'm just doing it wrong...

[mdmbc]

PWR_ON to GND works for me, but it needs to be held low for a few seconds.