|
how to enable I2C-0
|
05-09-2018, 01:08 PM
Hi, how can I enable i2c-0 on GPIO3 and GPIO5 of RPi header? I was trying latest armbian and Ayufans latest, but without any success - GPIO3 is permanently pulled down (booted from uSD)
If I posted something helpful, please rate +
05-09-2018, 09:10 PM
(05-09-2018, 01:08 PM)TeaPack Wrote: Hi, how can I enable i2c-0 on GPIO3 and GPIO5 of RPi header? I was trying latest armbian and Ayufans latest, but without any success - GPIO3 is permanently pulled down (booted from uSD) Latest Ayufan images? Post 0.6.27 it looks like all GPIO devices are disabled and you need to use overlays to enable them. Not the move I would have made... I think SPI and I2C should be available and ready to use OOTB, but then again, the RPi guys do the same thing. |
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Rock64 enable 1-wire to read DS18B20 or Dallas temperature sensor | Perry | 2 | 3,714 |
02-12-2021, 08:02 PM Last Post: Perry |
|
| Enable I2C, I2s, SPI in boot-config file? | HelgeMK | 3 | 8,206 |
08-14-2018, 10:59 AM Last Post: pas059 |
|
