GPIO Table

[Bullet64]

I have edit the wiki with table for GPIO

https://wiki.pine64.org/wiki/Quartz64#GPIO_Pins

Can someone please check it? Thanks.

Source: https://wiki.pine64.org/images/3/31/Quar...201215.pdf

[CounterPillow]

According to pgwipeout, pin 7 right now is likely to just be a regular GPIO (GPIO0_A0), as he has been unable to actually get CPU_REFCLK_OUT from there. You can try this hypothesis by wiring an LED through a 220 Ohm resistor between it and GND, and then running gpioset 0 0=1 but this probably all depends on your device tree and kernel you're running.

Some more notes on the GPIOs I've written up based on the schematics a while ago:

• pin 3 (I2C3_SDA_M0): can be pwm, pulled high to 3.3V through 2.2kOhm resistor
  
• pin 5 (I2C3_SCL_M0): can be pwm, pulled high to 3.3V through 2.2kOhm resistor
  
• pin 12 (UART0_TX): can be pwm
  
• pin 14 (UART0_RX): can be pwm
  
• pin 18 (SPDIF_OUT): low-pass filtered with cutoff of 220 MHz
  

I might add those as notes to the wiki table later when I get the time.

It's also important to note that these are the GPIO bus assignments for the Model A. But we can do the wiki formatting distinction when the Model B ever sees the light of day.