PINE64
xhci-hcd xhci-hcd.6.auto: ERROR Transfer event for disabled endpoint - Printable Version

+- PINE64 (https://forum.pine64.org)
+-- Forum: ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=98)
+--- Forum: Linux on RockPro64 (https://forum.pine64.org/forumdisplay.php?fid=101)
+--- Thread: xhci-hcd xhci-hcd.6.auto: ERROR Transfer event for disabled endpoint (/showthread.php?tid=6981)

xhci-hcd xhci-hcd.6.auto: ERROR Transfer event for disabled endpoint - jzhang18 - 12-21-2018

I am using 4.4.132-1075-rockchip-ayufan kernel on Rockpro64 4GB board.

I boot from PCIe  SSD as roofs  and USB3 connecting a Seagate 2TB hard drive.

I recently notice this error:


Code:
xhci-hcd xhci-hcd.6.auto: ERROR Transfer event for disabled endpoint or incorrect stream ring



How to solve the error?

Thanks in advance.

RE: xhci-hcd xhci-hcd.6.auto: ERROR Transfer event for disabled endpoint - Bullet64 - 12-22-2018

I was so annoyed by the mistake that I switched to Armbian. Since the error does not appear anymore.

RE: xhci-hcd xhci-hcd.6.auto: ERROR Transfer event for disabled endpoint - jzhang18 - 12-23-2018

(12-22-2018, 01:17 AM)Bullet64 Wrote: I was so annoyed by the mistake that I switched to Armbian. Since the error does not appear anymore.

For Rock64,  I switched to Armbian,  it seems pretty good to me,  the 4 cores are all using the maximum frequency of RK3328: 1.5 Ghz

Pine64 stocked image for Rock64 is limited to 1.2Ghz

For Rockpro64,  I assume,  in Armbian, it will use 2.0 Ghz to 2 big cores,  1.5Ghz for 4 LITTLE cores. 

Could you confirm with me from your board?  Thank you in advance.

I have NanoPC T4 using the same RK3399 CPU as Rockpro64.   With Armbian,  I can achieve:  2.0 Ghz of 2 big cores,  1.5Ghz for 4 LITTLE cores, boot from NVMe as rootfs.

I don't know why  board manufactures are so conservative to use 1.8 Ghz for 2 big cores and 1.3Ghz for 4 LITTLE cores.

RE: xhci-hcd xhci-hcd.6.auto: ERROR Transfer event for disabled endpoint - Bullet64 - 12-23-2018

I think this screenshot will answer your questions.  Wink

https://nextcloud.frank-mankel.org/s/JqeaCiTxDHagqeC

RE: xhci-hcd xhci-hcd.6.auto: ERROR Transfer event for disabled endpoint - jzhang18 - 12-24-2018

(12-23-2018, 01:15 PM)Bullet64 Wrote: I think this screenshot will answer your questions.  Wink

https://nextcloud.frank-mankel.org/s/JqeaCiTxDHagqeC

Looks really good to me.   I should start it with Armbian at beginning!

Now I need to reinstall all those software again:

Apache2, Tomcat, MySQL, Guacamole, Seafile, Nextcloud, PLEX etc... Huh