PINE64

Full Version: Assembling the premium aluminum case
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I just purchased another Rock64 to build another NAS using OMV and I decided to get the premium aluminum case this time.  It arrived with no instructions and I have a couple of questions:

1) The kit includes 2 pieces of blue thermal tape and a little packet of thermal compound.  Am I supposed to use all three (stacked) in the assembly?

2) There is a little acrylic light pipe that looks like it should go in a hole near the white and red LEDs but it is too big.  Do I just need to drill the hole in the case out a little?

Thanks for any help from those who've gone before me.

Marc
(01-01-2019, 02:22 PM)mlefevre Wrote: [ -> ]I just purchased another Rock64 to build another NAS using OMV and I decided to get the premium aluminum case this time.  It arrived with no instructions and I have a couple of questions:

1) The kit includes 2 pieces of blue thermal tape and a little packet of thermal compound.  Am I supposed to use all three (stacked) in the assembly?

2) There is a little acrylic light pipe that looks like it should go in a hole near the white and red LEDs but it is too big.  Do I just need to drill the hole in the case out a little?

Thanks for any help from those who've gone before me.

Marc

In the same boat. Board + case arrived. No assembly instructions. Can do what seems right, or hope somebody has documented the correct steps. Not sure I have that light pipe, but I may have just missed it. 

Tom
Thanks for pointing out that there are no instructions for assembly. When you DO get it right, would you please make a wiki entry (use your forum creds) explaining the assembly?
The words Premium Case and zero assembly instructions included seems a little bit of a contradiction. I'd hate to see what the standard case didn't include.
Pics on the ameriDroid site of this case reveal two things: 1. the light pipe (found mine) goes into the larger of the 3 holes near the LEDs. It doesn't fit as delivered, so some tweaking needed. 2. The thermal tape is applied to the case extension that overhangs the two central chips that want some cooling. I suspect the thermal paste can be smeared atop the chips and when the case is closed the needed physical contact is made.

Pics viewed here https://ameridroid.com/collections/cases...minum-case
Assemble rock64 SBC into premium aluminum case:

+Remove four screws holding case top to bottom, remove top.
+Put gold coloured “legs” between SBC bottom and case, atop case screw holes, attached using shorter of two sets of screws that came with case.

Reasoned that SBC board was thicker than aluminum of case.

+Secure board to the “legs” using longer of the two sets of screws, ensuring its orientation aligned the cable ports properly with holes for same in case.

Note there appears to be one extra screw of each set, long and short. Thoughtful for the finger fumbling types.

Wee light tube does not fit into appropriate hole to transmit on/off LED.

+Ream the light tube hole lightly with a 1/8” drill bit by hand to clean off paint inside the hole. Light tube presses in easily after that.
+Stick thicker of the two thermal tape pieces to heat sink part of case.

Had done a test fit of thicker thermal tape sandwiched between heat sink and chips, lid on. Shook it all around a lot, then found tape in same position when case reopened. Didn't test the thinner piece; maybe it works too.

+Put thermal compound on chips. Remove the plastic on exposed piece of thermal tape.
+Position case top, secure with screws.

Done.