correct there is no touch screen. The cable coming off the screen will plug directly into the DSI port(its is a 30pin .5mm pitch ribbon), but it is very short and I do not recommend it for purposes other than testing. Unless you make a housing that will properly secure this setup you should buy an extension. It's a basic part and cheap, for example:
https://www.ebay.com/i/162768952020?chn=ps
There are number available. I think you can get these from somewhere like mouser as well.
I have almost found the touch panel separate as well, but not with the correct cable. I think that most of these touch panels come with a straight cable that goes into a touch panel ic, but the one used by the pine is a bit different and has an ic inline on the ribbon cable.
If I am incorrect someone let me know.
https://www.ebay.com/i/162768952020?chn=ps
There are number available. I think you can get these from somewhere like mouser as well.
I have almost found the touch panel separate as well, but not with the correct cable. I think that most of these touch panels come with a straight cable that goes into a touch panel ic, but the one used by the pine is a bit different and has an ic inline on the ribbon cable.
If I am incorrect someone let me know.