10-27-2016, 03:07 PM
(09-08-2016, 02:17 PM)MarkHaysHarris777 Wrote:Just got the lithium battery in the mail today. I understand how to install it and the jumper config. My question is; does the power supply recharge the battery when it's running the board? Also since this is a brand new battery should I do the usual charge for XX hours prior to running from the battery?(09-08-2016, 01:49 PM)alaskanson Wrote:(08-02-2016, 04:32 PM)MarkHaysHarris777 Wrote: With this setup (lennyraposo debian mate), the 2G PineA64 and motor speed controlled fan, usb receiver, LED GPIO lab, gps module (in the foreground) using as a full desktop PC mid to heavy loading, I am getting six (6) hours of continuous use from the Pine64 battery model 9070120p 8000 mah lithion.
This is fairly consistent between my LCD cb&dt Play Box running Android.
Nice! That is a decent stretch. Is it possible for this battery to power the multiport I2C as well? I've not found info online to help on this issue.
I have the 2Gb board and this very battery but using it turns off the POT.
-a
when running on batt, you MUST move the 5v|batt jumper to BATT. The jumper is next to the pine cone logo near the SD card slot. While running on batt, the 5v needs to come from the on-board batt regulator and WILL NOT unless you move the jumper to BATT.
Thanks,
Mike