11-05-2020, 03:06 AM
(09-10-2020, 09:06 AM)PureTryOut Wrote: Guys... The password used for full disk encryption, the one you enter every time you boot up the phone is not related to the pin it asks for once your device has booted, the one Phosh asks you. The installer forces you to setup a numerical pin only exactly for this and allows more types of characters for the full disk encryption.
If it doesn't accept your password then you're just typing it wrong. I'm not sure why so many people are having issues with this.
Not completely true! I had the same issue with the encryption passphrase being incorrect. I did notice the changes in the keyboard so I made the appropriate changes in how I typed the passphrase in and I tried it many times with many variations. The only way I was able to decrypt the drive was to boot the phone with jumpdrive 0.6 and use my laptop to enter the passphrase.
I suspect one that #1 or #2 listed below was the cause for my issues, although the key board would slide up super slow like it wasn't working correctly, and there was no prompt telling me to enter a passphrase until after I entered something and it resets. Either way there are definitely some software bugs
1) the onboard key pad for the decryption can not accept the tilde(~) characture
2) the password is too long
My password was 17 alpha characters long including one tilde character. The password also extended beyond the input box and went off the screen. I didn't look into an error codes or trouble shoot once I got into the drive remotely because I just wanted to get the phone booted so I could test it out, but I'm fairly confident that my particular issue was cause by one of the mentioned issues