HOW TO - Connect the serial console
#21
I've bought a ch340 uart converter from pine shop, it looks exactly like the one on the picture. But when I put the yellow jumper on 3v3, i get nothing in dmesg, only when I put the jumper on 5V I get USB device recognized in dmesg and the ttyUSB port is there, but then,, of course, I don't get anything on it since it is on 5V

This is on 5V
# dmesg | tail -f
[98293.116166] usb 3-1: new full-speed USB device number 3 using uhci_hcd
[98293.304184] usb 3-1: New USB device found, idVendor=1a86, idProduct=7523, bcdDevice= 2.54
[98293.304187] usb 3-1: New USB device strings: Mfr=0, Product=2, SerialNumber=0
[98293.304190] usb 3-1: Product: USB2.0-Serial
[98293.307329] ch341 3-1:1.0: ch341-uart converter detected
[98293.314267] usb 3-1: ch341-uart converter now attached to ttyUSB0

this is on 3V3
(...)
nothing, nada, zilch Wink

any ideas? is my ch341 dead? My PC too old?
  Reply


Messages In This Thread
HOW TO - Connect the serial console - by Yoast - 08-12-2018, 07:49 AM
RE: HOW TO - Connect the serial console - by djb - 03-07-2019, 01:29 PM
RE: HOW TO - Connect the serial console - by Atch - 06-06-2020, 02:17 PM
RE: HOW TO - Connect the serial console - by aivanise - 05-06-2022, 06:44 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Serial Connection Tutorial: FTDI 232RL hmuller 0 2,011 10-23-2020, 11:56 AM
Last Post: hmuller

Forum Jump:


Users browsing this thread: 1 Guest(s)