07-23-2017, 06:38 AM
For the moment, I would forego connecting the power to the euler buss, since its working and power does not appear to be an issue; but, the way is you cut the cable and put female jumpers on the wire ends (requires crimping and solder) and then you plug the +5v line on pin(4) or pin(2), and plug the ground line (neg) to pin(6).
Your next step is going to find a monitor that supports 720p60 hdmi or 1080p60 hdmi ;
or, your next step is to connect a serial ttl to usb bridge cable to the pine board and plug the usb end into your pc, or mac; you can watch the bootup log there, and when its up you'll be able to logon there too ! From there you may be able to fix some hdmi or networking parms.
Good to know the board works !
Your next step is going to find a monitor that supports 720p60 hdmi or 1080p60 hdmi ;
or, your next step is to connect a serial ttl to usb bridge cable to the pine board and plug the usb end into your pc, or mac; you can watch the bootup log there, and when its up you'll be able to logon there too ! From there you may be able to fix some hdmi or networking parms.
Good to know the board works !
marcushh777
please join us for a chat @ irc.pine64.xyz:6667 or ssl irc.pine64.xyz:6697
( I regret that I am not able to respond to personal messages; let's meet on irc! )
please join us for a chat @ irc.pine64.xyz:6667 or ssl irc.pine64.xyz:6697
( I regret that I am not able to respond to personal messages; let's meet on irc! )