04-14-2023, 03:02 PM
Hi guys, I got my Pinecil v2 a few days ago; just transplanted the guts into the clear case and thought I'd try updating to the latest firmware. Running into a problem.
I'm running Windows 7 x64 - it won't recognize the Pinecil in flashing mode/won't install a driver. In Device Manager it shows up as "CDC Virtual ComPort" and says device drivers are not installed.
I followed the instructions to the letter: held down the "-" button when connecting and held it for 15s after, along with all the PowerShell and blisp instructions. Executing blisp results in "Device not found". I tried three different cables (one generic, and two Anker USB-A to USB-C. All three work fine flashing my backup TS101) and every USB port on the laptop.
Guidance would be appreciated. Thanks in advance!
P.S. When I hook it up without holding "-", it does boot up with the screen active as expected, and Device Manager shows it under USB Controllers as "Unknown Device", but also says "No drivers are installed for this device."
I'm running Windows 7 x64 - it won't recognize the Pinecil in flashing mode/won't install a driver. In Device Manager it shows up as "CDC Virtual ComPort" and says device drivers are not installed.
I followed the instructions to the letter: held down the "-" button when connecting and held it for 15s after, along with all the PowerShell and blisp instructions. Executing blisp results in "Device not found". I tried three different cables (one generic, and two Anker USB-A to USB-C. All three work fine flashing my backup TS101) and every USB port on the laptop.
Guidance would be appreciated. Thanks in advance!
P.S. When I hook it up without holding "-", it does boot up with the screen active as expected, and Device Manager shows it under USB Controllers as "Unknown Device", but also says "No drivers are installed for this device."