+- PINE64 (https://forum.pine64.org)
+-- Forum: Pinecil (https://forum.pine64.org/forumdisplay.php?fid=162)
+--- Forum: General Discussion on Pinecil (https://forum.pine64.org/forumdisplay.php?fid=163)
+--- Thread: my pinecil v2 is not working (/showthread.php?tid=20253)
my pinecil v2 is not working - jagrav - 04-17-2026
Hello,
If I connect to a power supply, the display only shows calibrating, and not work. If I push the + switch under connecting the power,
it shows PD debug State 3 No Vbus. After push the - switch, only shows calibrating...
Under firmware update there are handshake errors. So I cannot step through the "calibrating" word.
The display orientation is changes, as I turn the pinecil handle to other direction....
How do I reset the unit to a working state?