+- PINE64 (https://forum.pine64.org)
+-- Forum: Pinebook Pro (https://forum.pine64.org/forumdisplay.php?fid=111)
+--- Forum: Linux on Pinebook Pro (https://forum.pine64.org/forumdisplay.php?fid=114)
+--- Thread: new manjaro install: wlan0 stuck in setting network address (/showthread.php?tid=19650)
new manjaro install: wlan0 stuck in setting network address - zkajdan - 01-28-2025
Hi,
I am following this post:
https://forum.pine64.org/showthread.php?tid=10403
to install current Manjaro on the ponebook. So far, I have successfully installed Manjaro 23.02 on the sd card.
But from the new sd card installation, I cannot use wifi to download an image for the emmc install:
wlan0 is forever hanging in "connecting"/"setting network address".
ip link shows the interface as dormant. NetworkManager is running, and the nameserver setting is correct in /etc/resolv.conf. I can also ping the nameserver.
But ip route does not return anything.
Would anyone have an idea what is going wrong? Many thanks in advance!!
RE: new manjaro install: wlan0 stuck in setting network address - Kevin Kofler - 01-29-2025
At this point, I can only recommend trying another distribution:
https://blog.strits.dk/is-manjaro-arm-dead/
Manjaro ARM stable has not been updated for months, not even with security updates.
RE: new manjaro install: wlan0 stuck in setting network address - zkajdan - 02-03-2025
So sorry, I didn't get notified of your answer! Thank you so much!
Can you recommend a distribution to install now?
Thanks again!
RE: new manjaro install: wlan0 stuck in setting network address - mikehenson - 02-03-2025
(02-03-2025, 05:06 AM)zkajdan Wrote: So sorry, I didn't get notified of your answer! Thank you so much!
Can you recommend a distribution to install now?
Thanks again!
I just installed PostMarketOS on my PineBookPro. Easy and painless. Wifi works, I have not tried much more yet.
https://images.postmarketos.org/bpo/
Get image, unzip image, put on SD, put in PineBookPro.
Boot off SD, Get image again on PineBookPro, unzip image, dd to the eMMC
Turn off PineBook, take SD out, Turn on PineBookPro
RE: new manjaro install: wlan0 stuck in setting network address - zkajdan - 02-03-2025
Thanks Mike! That's good to know!