+- PINE64 (https://forum.pine64.org)
+-- Forum: PinePhone Pro (https://forum.pine64.org/forumdisplay.php?fid=177)
+--- Forum: General Discussion of PinePhone Pro (https://forum.pine64.org/forumdisplay.php?fid=178)
+--- Thread: Shutdown / Reboot PPP from TowBoot "Volume Up" USB Readable Drive Mode (/showthread.php?tid=18882)
Shutdown / Reboot PPP from TowBoot "Volume Up" USB Readable Drive Mode - crocspot - 11-18-2023
I'm assuming I've missed something ?
Wondering is there a (Correct) way to shutdown or reboot the PPP once it's TowBoot "Volume Up" booted into USB Readable Drive mode ?
I've tried just holding the power button down but I don't appear to be shutting down / rebooting after unplugging USB Cable / Connection ?
Sorry couldn't figure out if this should go under "Hardware" or "Software" ?
Ta for help
in advance.
RE: Shutdown / Reboot PPP from TowBoot "Volume Up" USB Readable Drive Mode - Halfgreek - 11-18-2023
(11-18-2023, 09:10 AM)crocspot Wrote: I'm assuming I've missed something ?
Wondering is there a (Correct) way to shutdown or reboot the PPP once it's TowBoot "Volume Up" booted into USB Readable Drive mode ?
I've tried just holding the power button down but I don't appear to be shutting down / rebooting after unplugging USB Cable / Connection ?
Sorry couldn't figure out if this should go under "Hardware" or "Software" ?
Ta for help
I have had this issue. I have been able to hold the power button down for a few seconds and it shuts down, but if you are unable to get it to power off than press the reset button on the inside of the phone or pulling the battery always works. I have tried the reset button and it doesn't really seem to do anything other than restart right away. Sometimes that is not what I want since the phone will come back on too quickly to do anything additional.
RE: Shutdown / Reboot PPP from TowBoot "Volume Up" USB Readable Drive Mode - DaForest - 11-19-2023
After flashing a distro to the PPP through towboot
1. unplug device from USB cable.
2. Press and hold power button UNTIL device shuts off.
3. Power on device.
This is the method that I have used to either flash a system or simply enter device through my laptop.
No issues to date.