+- PINE64 (https://forum.pine64.org)
+-- Forum: Quartz64 (https://forum.pine64.org/forumdisplay.php?fid=166)
+--- Forum: General Discussion on Quartz64 (https://forum.pine64.org/forumdisplay.php?fid=167)
+--- Thread: Need a working image for Quartz64B (/showthread.php?tid=17131)
RE: Need a working image for Quartz64B - diederik - 02-22-2023
That's my guess too, but it could also be an u-boot problem. If another boot loader would have the same issue, then it becomes even more likely to be a HW problem.
RE: Need a working image for Quartz64B - balbes150 - 02-23-2023
(02-22-2023, 04:42 AM)diederik Wrote: That's my guess too, but it could also be an u-boot problem. If another boot loader would have the same issue, then it becomes even more likely to be a HW problem.
The reason is not u-boot. Before it, a binary blob starts controlling the primary memory configuration, u-boot and EDK2 use almost the same primary blob. There is no output since the start of the primary loader , which means the hardware is not working.
RE: Need a working image for Quartz64B - diederik - 02-23-2023
(01-24-2023, 11:51 PM)balbes150 Wrote:(01-24-2023, 11:16 AM)diederik Wrote: I still need to look further into it, but I had the same issue with a Model-B, no output on both UART adapters (both woodpecker), while both work fine with Model-A.
The Model-B did work fine though (with Plebian), just no output on the serial console.
Yes, I have the same, there is no output to UART,
I think I've found the reason :-)
I have a Model B v1.4 and @CounterPillow appears to have a v1.3 and his serial is working.
Do you happen to have a v1.4 too?
RE: Need a working image for Quartz64B - balbes150 - 02-24-2023
Ver 1.4 2022.06.06