+- PINE64 (https://forum.pine64.org)
+-- Forum: PinePhone (https://forum.pine64.org/forumdisplay.php?fid=120)
+--- Forum: PinePhone Hardware (https://forum.pine64.org/forumdisplay.php?fid=122)
+--- Thread: 3/32 upgrade board, Arrived Without Firmware, Troubleshooting Steps to SOLVED (/showthread.php?tid=14251)
3/32 upgrade board, Arrived Without Firmware, Troubleshooting Steps to SOLVED - biketool - 06-22-2021
(skip to last edit to see solution, leaving all steps to make searching for solution easier)
I finally received my new 3/32 upgrade board for my pinephone.
I read the wiki and watched the video, and did the board swap.
It looks like it was not flashed with a bootloader at the factory?
Instead I see a LED flash from the back of the board when I insert the USB and then I lsusb I get
Code:
Onda (unverified) V972 tablet in flashing modeI also tried booting a jumpdrive SD but nothing happened, no bootloader, got the same lsusb response.
(edit)
I found a copy of the factory-test image(pine64-pinephone-20200726-phosh-v20.05-factory.img) on my computer and with that in the SD slot gave me a pink LED when I inserted USB.
I waited an 20min with the pink LED and dark screen in case anything was being flashed.
I then rebooted did the other tests and then chose the automated test, it is sitting for a long time at 12% testing the LIS3MDL after instantly testing MPU-6050.
this link should help you find the factory test image https://images.postmarketos.org/pinephone/
(edit)
For some reason my jumpdrive SD is not working/booting so I am DL'ing from this link the Debian image and will try that once the download is finished.
https://wiki.pine64.org/wiki/PinePhone_Software_Releases#Factory_Test_OS
(edit)
I got the Debian Factory image and booted it, run the auto-test, I don't outright fail and instantly passes the MPU-650, but I never pass the LIS3MDL, just hangs forever at 12% so I never get the option to flash......
(edit)
Got advice after opening a Pine64 service ticket, they recommended I go to
https://wiki.pine64.org/wiki/PinePhone_Software_Releases#Factory-loaded_OS_builds
choose the Beta Edition link and DD the image to SD
This image passes the tests and I am flashing my EMMC, I loaded the OS and ran setup, ran sudo halt and DD the latest JumpDrive to SD
https://github.com/dreemurrs-embedded/Jumpdrive/releases
Flashed Debian Mobile mobian-pinephone-phosh-20210421.img to EMMC via jumpdrive
Booted and ran Mobian setup on my Pinephone from a 3/32 upgrade board that arrived unconfigured.
now grabbing software updates, and will enable unstable repos once I have everything configured.
https://wiki.mobian-project.org/doku.php?id=faq#how-to-i-switch-to-mobian-unstable