+- PINE64 (https://forum.pine64.org)
+-- Forum: PINE A64(+) (https://forum.pine64.org/forumdisplay.php?fid=4)
+--- Forum: Linux on Pine A64(+) (https://forum.pine64.org/forumdisplay.php?fid=6)
+--- Thread: Possible IDE? (/showthread.php?tid=1083)
Possible IDE? - yuvgin - 05-18-2016
Hi,
I tried the hardware forum and got no response, so i'll try my luck here...
I'm looking for a free IDE and some instructions on how to create a simple and basic image of my own.
I'd like to control the GPIO pins and maybe experiment a bit with some UART communication.
I'm a hardware engineering student and have a bit of experience with MCUs. I just got my PINE last week, but had no luck in finding a proper tutorial or guide on how to fully control all the of the cool PINE features.
I saw that it may be possible using an eclipse based platform for ARM devices called DS-5, but once installed it didn't offer anything more than a empty editor and no explanations.
Any advice at all would be great!
Thanks!
RE: Possible IDE? - tllim - 05-18-2016
(05-18-2016, 06:05 AM)yuvgin Wrote: Hi,
I tried the hardware forum and got no response, so i'll try my luck here...
I'm looking for a free IDE and some instructions on how to create a simple and basic image of my own.
I'd like to control the GPIO pins and maybe experiment a bit with some UART communication.
I'm a hardware engineering student and have a bit of experience with MCUs. I just got my PINE last week, but had no luck in finding a proper tutorial or guide on how to fully control all the of the cool PINE features.
I saw that it may be possible using an eclipse based platform for ARM devices called DS-5, but once installed it didn't offer anything more than a empty editor and no explanations.
Any advice at all would be great!
Thanks!
Welcome, for GPIO, this may be a good place to start: http://linux-sunxi.org/GPIO