+- PINE64 (https://forum.pine64.org)
+-- Forum: ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=98)
+--- Forum: General Discussion on ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=99)
+--- Thread: RP64 Mounting hole dimensions (/showthread.php?tid=7941)
RP64 Mounting hole dimensions - Wallaby - 09-07-2019
Hello, I have been trying to find the exact dimensions of the mounting holes for the RP64 since I got it. I have been looking in the wiki and I can't seem to find the dimensions.
There are nice schematics on the wiki with lots of information, however I can't find dimensions anywhere. I have tried to measure the distance between the holes and the holes themselves, but I don't have the tools to get them right.
I would be grateful if someone has them or could point me to them. It should be easy to find since someone has designed the board, I would like to think.
Thanks in advance.
RE: RP64 Mounting hole dimensions - patstew - 09-07-2019
I've had my own case built and used 118.292 x 70.735 mm as the centre to centre dimensions.
RE: RP64 Mounting hole dimensions - Wallaby - 09-08-2019
(09-07-2019, 10:48 AM)patstew Wrote: I've had my own case built and used 118.292 x 70.735 mm as the centre to centre dimensions.
Thank you, I guess I will have to try your dimensions!