![]() |
Extremely low write speed on GB ethernet - Printable Version +- PINE64 (https://forum.pine64.org) +-- Forum: ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=98) +--- Forum: General Discussion on ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=99) +--- Thread: Extremely low write speed on GB ethernet (/showthread.php?tid=6690) |
Extremely low write speed on GB ethernet - omer811 - 10-22-2018 Hello, I've had a problem with the write speeds I'm getting over wired connection, I'm only getting about 2-4 MBps at best, when I expect at least 60. I'v installed auyfan's stretch-openmediavault-rockpro64-0.7.10-1072-armhf, the device is connected to a gigabit router, also tested connecting it directly to my machine with similar results. I'm suspecting it had something to do with the Realtek RTL8211 driver not installed correctly, Code: root@rockpro64:~# ethtool -i eth0 Is there any way to try and install the correct driver for this chip? Thanks, Omer. RE: Extremely low write speed on GB ethernet - evilbunny - 10-22-2018 (10-22-2018, 06:53 AM)omer811 Wrote: Hello, Have you tried disabling rx/tx offloading? https://github.com/ayufan-rock64/linux-build/issues/263 RE: Extremely low write speed on GB ethernet - omer811 - 10-24-2018 apparently it was not a problem with the connection, but with the drives that are connected. when under load, the usb connection the the drives that are connected to the hub crashes. https://pastebin.com/JGM3xKDz the hub is a-4 port powered hub by Anker, and two powered sumsung disks are connected to it hub's lsusb - https://pastebin.com/MiAMh9K5 I'm running 4.4.154-1122-rockchip-ayufan-g7859b9b904a9 with OMV installed i'v tried the following advice https://bbs.archlinux.org/viewtopic.php?id=183190 on comment #12, which helped a little, the drives became more stable, but disconnected after all. |