+- PINE64 (https://forum.pine64.org)
+-- Forum: ROCK64 (https://forum.pine64.org/forumdisplay.php?fid=85)
+--- Forum: General Discussion on ROCK64 (https://forum.pine64.org/forumdisplay.php?fid=86)
+--- Thread: Unable to boot from SPI (/showthread.php?tid=6223)
Unable to boot from SPI - stevefan1999 - 06-29-2018
So I had flashed my SPI via SD card method, I waited until the LED goes blinking and turned off the device, and then I flashed my USB 3.0 drive to OMV with Etcher in Windows, and now it isn't booting at all! HDMI has no signal after I started the booting, neither was there any blinkings anymore, I have very limited hardware debugging skill and I simply want to know how to restore access to my Rock64, thank you.
RE: Unable to boot from SPI - stevefan1999 - 06-29-2018
Strange. So I was able to access the OMV web panel in my bet to check the DHCP list of my router, but there was no visible HDMI output. I checked the cable is completely fine, I'm very confused right now...
RE: Unable to boot from SPI - stevefan1999 - 07-19-2018
Any help? I need HDMI to debug certain stuff...
RE: Unable to boot from SPI - tllim - 07-22-2018
(06-29-2018, 06:16 AM)stevefan1999 Wrote: So I had flashed my SPI via SD card method, I waited until the LED goes blinking and turned off the device, and then I flashed my USB 3.0 drive to OMV with Etcher in Windows, and now it isn't booting at all! HDMI has no signal after I started the booting, neither was there any blinkings anymore, I have very limited hardware debugging skill and I simply want to know how to restore access to my Rock64, thank you.
If you thinks is cause by SPI Flash implementation, you can ease SPI Flash using below link:
http://wiki.pine64.org/index.php/NOOB#Erasing_and_Rewriting_SPI
RE: Unable to boot from SPI - rhens1 - 05-01-2019
(07-22-2018, 07:26 AM)tllim Wrote:(06-29-2018, 06:16 AM)stevefan1999 Wrote: So I had flashed my SPI via SD card method, I waited until the LED goes blinking and turned off the device, and then I flashed my USB 3.0 drive to OMV with Etcher in Windows, and now it isn't booting at all! HDMI has no signal after I started the booting, neither was there any blinkings anymore, I have very limited hardware debugging skill and I simply want to know how to restore access to my Rock64, thank you.
If you thinks is cause by SPI Flash implementation, you can ease SPI Flash using below link:
http://wiki.pine64.org/index.php/NOOB#Erasing_and_Rewriting_SPI
I'm having the same problem after using the U-boot erase program. I also waited until the LED started a continuous blinking. I then turned the machine off and now can't read from the SPI. I had been using the USB for SSDs and µSD holders. Now there is no response ... ability to read anything. The Internet port also appears to be dead. I have a number of good builds, but the won't boot.