+- PINE64 (https://forum.pine64.org)
+-- Forum: ROCK64 (https://forum.pine64.org/forumdisplay.php?fid=85)
+--- Forum: Rock64 Hardware and Accessories (https://forum.pine64.org/forumdisplay.php?fid=89)
+--- Thread: Pinning of A/V jack (/showthread.php?tid=6133)
Pinning of A/V jack - Osiander - 06-02-2018
Hello together,
I need an adapter / cable for video output of my Rock64 board.
Is this pinning of the plug correct?
TIP = GND
first RING after the TIP = video / cvbs
second RING after the TIP = right channel
SLEEVE = left channel
Is that correct?
Many thanks.
RE: Pinning of A/V jack - MichaelRock - 06-04-2018
Hi,
according to schematic available on Rock64's resources page:
L
---
R
---
CVBS_OUT
---
GND (tip)
(the arrow -v- show contact area, the big rectangle is most probably the end of the jack itself unless it's backward)
So you're right
.
RE: Pinning of A/V jack - Osiander - 06-04-2018
Hello Michael,
thank you very much for confirmation
RE: Pinning of A/V jack - NachoGomez - 12-03-2018
(06-04-2018, 03:22 AM)Osiander Wrote: Hello Michael,
thank you very much for confirmation
Hello Osiander!
Would you confirm if the suggested pinout combination worked for you? I actually read the schematics backwards as suggested here, I'm not an expert, but it is how understood the schematics and I'd just like to confirm before buying an A/V cable.
Thanks in advance, regards...