+- PINE64 (https://forum.pine64.org)
+-- Forum: PINE A64(+) (https://forum.pine64.org/forumdisplay.php?fid=4)
+--- Forum: General Discussion on PINE A64(+) (https://forum.pine64.org/forumdisplay.php?fid=3)
+--- Thread: PINE64/ROCK64 infra receiver power on (/showthread.php?tid=5225)
PINE64/ROCK64 infra receiver power on - cserem - 10-06-2017
Hello,
On the PINE64 board there is an infra header. With the diode installed, is it capable of turning ON the board, or just turning it OFF?
I am interested in the answer for the ROCK64 board too, which has an infra receiver installed already: can it be used to power ON the device, or only to shut it down with the remote?
Thank you
RE: PINE64/ROCK64 infra receiver power on - MarkHaysHarris777 - 10-06-2017
(10-06-2017, 06:41 AM)cserem Wrote: On the PINE64 board there is an infra header. With the diode installed, is it capable of turning ON the board, or just turning it OFF?
I am interested in the answer for the ROCK64 board too, which has an infra receiver installed already: can it be used to power ON the device, or only to shut it down with the remote?
On the PineA64 it may only be used to power OFF; but it may NOT be used to power ON. This is a restriction on the way the AXP803 ( PMIC ) works with the SoC & system.
On the Rock64 it 'may' be possible to power ON, but the IR receiver so far has received very little attention; out-of-box it does not work ( has no input device ) in linux; does work in a limited way in Android. In the future the IR receiver will get more attention I'm sure.
