PINE64
How to open the CSI? - Printable Version

+- PINE64 (https://forum.pine64.org)
+-- Forum: PINE A64(+) (https://forum.pine64.org/forumdisplay.php?fid=4)
+--- Forum: Pine A64 Hardware, Accessories and POT (https://forum.pine64.org/forumdisplay.php?fid=32)
+---- Forum: Camera Module (https://forum.pine64.org/forumdisplay.php?fid=38)
+---- Thread: How to open the CSI? (/showthread.php?tid=2117)



How to open the CSI? - NWUK - 08-30-2016

Hi,

I just wanted to double check before I break anything.

The CSI connector has a white part on the top and a darker part on the bottom. To open it, you need to push the white part up, correct? then slot in the camera and close it again.

Thanks,


RE: How to open the CSI? - MarkHaysHarris777 - 08-30-2016

NO

You very gently lift the black bar up with your finger nail... no metal tools... and be VERY careful because it is easily broken.

slide the camera cable into the connector with the contact pads down (towards the board) and close the black bar.


RE: How to open the CSI? - NWUK - 08-31-2016

(08-30-2016, 04:16 PM)MarkHaysHarris777 Wrote: NO

You very gently lift the black bar up with your finger nail... no metal tools... and be VERY careful because it is easily broken.

slide the camera cable into the connector with the contact pads down (towards the board) and close the black bar.

Thank you! 

Glad I asked and thanks for the quick answer


RE: How to open the CSI? - MarkHaysHarris777 - 08-31-2016

(08-31-2016, 01:15 AM)NWUK Wrote:
(08-30-2016, 04:16 PM)MarkHaysHarris777 Wrote: NO

You very gently lift the black bar up with your finger nail... no metal tools... and be VERY careful because it is easily broken.

slide the camera cable into the connector with the contact pads down (towards the board) and close the black bar.

Thank you! 

Glad I asked and thanks for the quick answer

welcome !

Big Grin