Quartz64 Model A fan - Printable Version +- PINE64 (https://forum.pine64.org) +-- Forum: Quartz64 (https://forum.pine64.org/forumdisplay.php?fid=166) +--- Forum: Quartz64 Hardware and Accessories (https://forum.pine64.org/forumdisplay.php?fid=169) +--- Thread: Quartz64 Model A fan (/showthread.php?tid=18243) |
Quartz64 Model A fan - TeutonicTovarish - 05-19-2023 Hi, I recently purchased a Quartz64 model A 4GB and installed DietPi using a 32gb SD card. Once done with setup, I installed it in its case and connected a fan (which I bought from the pine store) to the 2 pin connector on the board. The fan does not function. Do I have to install a fan controller? If so, would anyone have recommendations? RE: Quartz64 Model A fan - diederik - 05-20-2023 (05-19-2023, 08:18 PM)TeutonicTovarish Wrote: Hi, I recently purchased a Quartz64 model A 4GB and installed DietPi using a 32gb SD card. Once done with setup, I installed it in its case and connected a fan (which I bought from the pine store) to the 2 pin connector on the board. The fan does not function. Do I have to install a fan controller? If so, would anyone have recommendations? AFAIK it works OOTB, but it only spins when needed (>55C IIUC). https://wiki.pine64.org/wiki/ROCKPro64#Working_Features does mention ATS - Active Thermal Service so you could try that |