+- PINE64 (https://forum.pine64.org)
+-- Forum: General (https://forum.pine64.org/forumdisplay.php?fid=1)
+--- Forum: General (https://forum.pine64.org/forumdisplay.php?fid=74)
+--- Thread: on pinepower, pinecil stopped working.. (/showthread.php?tid=17382)
on pinepower, pinecil stopped working.. - sanderboer - 09-22-2022
Hi,
when I plug in the pinecil in the pinepower, the latter shows 5.1V 0.0A and the pinecil stays off.
Worried the pinecil was bricked, I tried a regular usb-c and the pinecil comes on like no problem (except for the DC-LOW message)
I updated the firmware for a laugh, succeeded, but the pinepower fails me again.
I tried another cable, but that changed nothing.
Any help, tips or tricks would be greatly appreciated !
thx S
RE: on pinepower, pinecil stopped working.. - biketool - 09-23-2022
(09-22-2022, 09:01 AM)sanderboer Wrote: Hi,
when I plug in the pinecil in the pinepower, the latter shows 5.1V 0.0A and the pinecil stays off.
Worried the pinecil was bricked, I tried a regular usb-c and the pinecil comes on like no problem (except for the DC-LOW message)
I updated the firmware for a laugh, succeeded, but the pinepower fails me again.
I tried another cable, but that changed nothing.
Any help, tips or tricks would be greatly appreciated !
thx S
I had the same problem when I had a USB lamp plugged in, it set the whole pinepower to 5v, do you have a USB-2 item plugged in too forcing the 5v?