+- PINE64 (https://forum.pine64.org)
+-- Forum: Pinebook Pro (https://forum.pine64.org/forumdisplay.php?fid=111)
+--- Forum: General Discussion on Pinebook Pro (https://forum.pine64.org/forumdisplay.php?fid=112)
+--- Thread: Pinebook Pro bricked after flashing eMMC (/showthread.php?tid=16112)
Pinebook Pro bricked after flashing eMMC - User 24592 - 02-17-2022
I flashed Manjaro-ARM-kde-plasma-pbpro-21.12 to eMMC from a SD boot as described at https://wiki.pine64.org/wiki/NOOB#Flashing_to_eMMC_from_a_SD_Boot.
After rebooting, my Pinebook Pro got stuck at the Manjaro logo with the spinning circle.
When I press the Esc key, I see the following message, but the shell does not recognize any keystrokes:
Code:
:: running hook [udev]
:: Triggering uevents...
:: running hook [plymouth]
:: performing fsck on '/dev/mmcblk2p2'
ROOT_MNJRO: The filesystem size (according to the superblock) is 15205335 blocks
The physical size of the device is 1763287 blocks
Either the superblock or the partition table is likely to be corrupt!
ROOT_MNJRO: UNEXPECTED INCONSISTENCY; RUN fsck MANUALLY.
(i.e., without -a or -p options)
ERROR: Bailing out. Run 'fsck /dev/mmcblkp2' manually
********** FILESYSTEM CHECK FAILED **********
* *
* Please run fsck manually. After leaving *
* this maintance shell, the system will *
* reboot automatically. *
* *
*********************************************
sh: can't access tty; job control turned off
[rootfs /]#I tried booting from the SD card again, but it does not seem to work as I end up with the same message as above.
Please help!